Compression Fittings

Visiting our FAQ to learn more about Polyware.

Category > Compression Fittings

01
When pressurized the assembled fitting, water leaks from the connection joint?
  1. Ensure the PE pipe used compliance to standard ISO4427/DIN8074/MS1058/EN12201 in term of dimensional specification. Refer to the attached PE pipe dimension table.
  2. Ensure the pipe end cut with even and flat surface.
  3. Ensure the pipe insertion reach the inner stopper of the fitting body.
  4. Fully tighten the locking nut with hand and with the help of strap wrench

Switch To Desktop Version